Firmware Update v3.6.0

Based on the various feedback and reports, we’ve updated the firmware to version v3.6.0,
and we’re excited to share the details with you.

Autopro X Firmware v3.6.0 Updates

  • Multi-touch support for Android Auto

    Available for vehicles that support wired Android Auto.

  • Lincoln Continental 2019

    Once connected, select the Android Auto icon from the default interface to enter the system.

  • Genesis GV80

    The audio now works properly after switching the AV system off and then back on.

  • Improved navigation audio output in Android Auto mode

    For KGM’s Torres, Torres EVX, Actyon.

  • Improved top screen touch functionality

    Affected models: ccNC, some KGM models, etc.
    Tap the gear icon in the top right corner of Autopro X mode to switch to 'Touch Calibration Mode,' which adjusts the resolution to avoid unresponsive touch areas at the top and bottom of the screen.
    This mode is only available in firmware version 3.6.0 or higher.
    The update will remove the 16:9 screen ratio mode, leaving only full-screen and Touch Calibration Mode.
    If you're using 16:9 without any issues, there's no need to update.
※ Please disconnect Autopro X when updating your car's built-in navigation system to avoid any potential firmware issues.
※ When updating through the app, even if it shows 100%, please don’t close the update screen right away. Keep it open for another 2-3 minutes to ensure the main screen fully loads before closing. If an error occurs due to closing too soon, the device may need to be repaired through A/S support, so please be aware.

We’d like to thank our community members again for your continued feedback.
We’ll keep you updated with future developments!